This work was carried out under the auspices of the CoolTiTech project, which was funded by the German Federal Ministry of Economics and Technology (BMWi) under the LuFo IV-3 program. The financial support of the German BMWi is gratefully acknowledged. The authors also thank the following project members for their valuable work and support: Mr. K. Erdmann (mechanical testing), Mr. P. Haack (X-ray testing), Mr. R. Dinse (LBW), Mr. F. Dorn (metallography/EBSD), and Mr. L. Bieneck (cone-cup tests).
Microstructure and Mechanical Properties of Laser Beam Welded Joints between Fine-Grained and Standard Ti-6Al-4V Sheets Subjected to Superplastic Forming†
Version of Record online: 2 JUL 2014
© 2014 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim
Advanced Engineering Materials
Volume 17, Issue 3, pages 374–382, March 2015
How to Cite
Kashaev, N., Ventzke, V., Horstmann, M., Riekehr, S., Yashin, G., Stutz, L. and Beck, W. (2015), Microstructure and Mechanical Properties of Laser Beam Welded Joints between Fine-Grained and Standard Ti-6Al-4V Sheets Subjected to Superplastic Forming. Adv. Eng. Mater., 17: 374–382. doi: 10.1002/adem.201400202
- Issue online: 9 MAR 2015
- Version of Record online: 2 JUL 2014
- Manuscript Accepted: 4 JUN 2014
- Manuscript Received: 25 APR 2014
A fine-grained Ti–6Al–4V sheet that has been developed for superplastic forming (SPF) was joined to a standard Ti–6Al–4V sheet using a Nd:YAG laser and alloy compatible filler wire. The microstructural and mechanical properties of dissimilar laser beam welded butt joints were investigated to determine their behavior under static and cyclic loads and for SPF. The filler wire affected the heat input and reduced the increase in the hardness within the fusion zone compared to that in the heat-affected zone. The laser beam welding process activated local microstructure transformations that were associated with local changes in the microtexture, the β content, and the grain size. The mechanical behavior of a dissimilar laser beam welded butt joint under a static tensile load was controlled by the properties of the standard Ti–6Al–4V sheet. Laser beam welded specimens showed inferior fatigue behavior. Removing the geometrical notches did not significantly improve the fatigue behavior because local microstructural and microtextural changes still created metallurgical notches. SPF was observed in the fine-grained Ti–6Al–4V sheet without crack formation in the heat-affected zones or the fusion zone. The welding seam of the dissimilar fine-grained-standard butt joint was resistant to SPF.