Correction: On the Principles of Printing Sub-micrometer 3D Structures from Dielectric-Liquid-Based Colloids

Authors

  • N. C. Schirmer,

  • S. Ströhle,

  • M. K. Tiwari,

  • D. Poulikakos*

Errata

This article corrects:

  1. On the Principles of Printing Sub-micrometer 3D Structures from Dielectric-Liquid-Based Colloids Volume 21, Issue 2, 388–395, Article first published online: 9 November 2010

Two corrections in the above manuscript should be noted:

The estimated velocity value O(10−3 m s−1) reported in line 2 of page 390 was not measured directly. A discussion about a revised theoretical estimate of the velocity is provided in the Supporting Information. The value of the electrical conductivity reported in the Section 2.1 is not accurate, as established using a new and more precise measurement setup. The detailed repercussions of these corrections are clearly discussed in the Supporting Information.

Ancillary