Temperature-induced morphology control in the polymer-foaming process

Authors

  • L. J. M. Jacobs,

    Corresponding author
    1. Process Development Group, Dept. of Chemical Engineering and Chemistry, Eindhoven University of Technology, 5600 MB Eindhoven, The Netherlands
    • Process Development Group, Dept. of Chemical Engineering and Chemistry, Eindhoven University of Technology, 5600 MB Eindhoven, The Netherlands
    Search for more papers by this author
  • M. F. Kemmere,

    1. Process Development Group, Dept. of Chemical Engineering and Chemistry, Eindhoven University of Technology, 5600 MB Eindhoven, The Netherlands
    Search for more papers by this author
  • J. T. F. Keurentjes,

    1. Process Development Group, Dept. of Chemical Engineering and Chemistry, Eindhoven University of Technology, 5600 MB Eindhoven, The Netherlands
    Search for more papers by this author
  • Ch. A. Mantelis,

    1. Groupe des Procédés Macromoléculaires, Ecole Polytechnique Fédérale de Lausanne, Station 6, CH-1015 Lausanne, Switzerland
    Search for more papers by this author
  • Th. Meyer

    1. Groupe des Procédés Macromoléculaires, Ecole Polytechnique Fédérale de Lausanne, Station 6, CH-1015 Lausanne, Switzerland
    Search for more papers by this author

Abstract

Supercritical carbon dioxide (scCO2) is a promising foaming agent for the production of polymeric foams, representing an environmentally friendly alternative for the foaming agents currently used. During the expansion phase of the scCO2-foaming process, temperature plays an essential role. This study focuses on relating the effects of temperature and pressure profiles on the foaming process and the resulting foam morphology. Therefore, several experiments have been performed in a high pressure reaction calorimeter (RC1e) that can be set to three different modes: isothermal, adiabatic, and isoperibolic. It has been observed that the foaming could be divided into four stages: nucleation, slow cell growth, fast cell growth, and shrinkage. The degree of shrinking that occurs is for a great deal dependent on the exposure to higher temperatures at the end of the foaming process. Since shrinkage does not occur in the adiabatic mode, this mode gives the best control on the foam morphology. © 2007 American Institute of Chemical Engineers AIChE J, 2007

Ancillary