Registered trademark of E. I. du Pont de Nemours & Co., Inc.
Article first published online: 9 MAR 2003
Copyright © 1961 John Wiley & Sons, Inc.
Journal of Applied Polymer Science
Volume 5, Issue 16, pages 460–467, July/August 1961
How to Cite
Smith, J. F. and Perkins, G. T. (1961), The mechanism of post cure of viton A Fluorocarbon elastomer. J. Appl. Polym. Sci., 5: 460–467. doi: 10.1002/app.1961.070051612
Based on a lecture delivered at the 2nd International Synthetic Rubber Symposium, London, October 1960, by arrangement with Rubber and Plastics World.
- Issue published online: 9 MAR 2003
- Article first published online: 9 MAR 2003
- Manuscript Received: 22 DEC 1960
The necessity for oven post-curing Viton A vulcanizates is explained in the following way: The formation of crosslinks is accompanied by the elimination of HF from the polymer. In the subsequent reaction of HF with the magnesium oxide present as acid acceptor water is formed which acts to inhibit the full development of cure unless it is removed from the vicinity of the polymer by post-curing in an open system. Measurement of the rate of elimination of water from the polymer serves as a method of following the development of crosslinking during cure. Approximately two moles of water, derived from four moles of hydrogen fluoride, are associated with the use of one mole of diamine curing agent. This ratio is confirmed by independent estimates of the relationship of crosslinking density to curing agent level based on measurements of swollen compression moduli.