A problem with the synthesis of polymer/clay composites is the poor compatibility between clay and polymers; this is particularly bad for those with a high percentage of clay. In response, we introduced a freeze–thaw–extrusion process before polymerization to make the best use of the high activation ability of acrylic acid (the monomer) and the exceptional hydration of palygorskite (clay). This processing was powerful for facilitating clay dispersed into the nanoscale and for obtaining good compatibility with the polymer, even for those polymers with high clay contents. The experiment showed that the quality of the consequent superabsorbent was improved significantly. As the dispersion was worked out perfectly by the freeze–thaw–extrusion process, we further explored the effect of the system water content on the water absorptivity of the consequent composite. With synthesis by the improved system, the water absorbency still amounted to 98.2 g/g in a 0.9 wt % NaCl solution for the composite with 35 wt % clay, whereas the water content (55 wt %) was much less than that of general synthesis (ca. 95 wt %). Scanning electron microscopy showed that the composite had a rich pore structure in the range of several hundred nanometers, and the palygorskite was distributed perfectly in the composite on the nanoscale. Fourier transform infrared spectroscopy gave further direct evidence for the reaction between the clay and polymer. © 2012 Wiley Periodicals, Inc. J. Appl. Polym. Sci., 2013
If you can't find a tool you're looking for, please click the link at the top of the page to "Go to old article view". Alternatively, view our Knowledge Base articles for additional help. Your feedback is important to us, so please let us know if you have comments or ideas for improvement.