Optimal design of a thermally coupled fluidised bed heat exchanger reactor for hydrogen production and octane improvement in the catalytic naphtha reformers

Authors

  • E. Pourazadi,

    1. Department of Chemical Engineering, School of Chemical and Petroleum Engineering, Shiraz University, P.O. Box 71345, Shiraz, Iran
    Search for more papers by this author
  • R. Vakili,

    1. Department of Chemical Engineering, School of Chemical and Petroleum Engineering, Shiraz University, P.O. Box 71345, Shiraz, Iran
    Search for more papers by this author
  • D. Iranshahi,

    1. Department of Chemical Engineering, School of Chemical and Petroleum Engineering, Shiraz University, P.O. Box 71345, Shiraz, Iran
    Search for more papers by this author
  • A. Jahanmiri,

    1. Department of Chemical Engineering, School of Chemical and Petroleum Engineering, Shiraz University, P.O. Box 71345, Shiraz, Iran
    Search for more papers by this author
  • M. R. Rahimpour

    Corresponding author
    1. Department of Chemical Engineering, School of Chemical and Petroleum Engineering, Shiraz University, P.O. Box 71345, Shiraz, Iran
    • Department of Chemical Engineering, School of Chemical and Petroleum Engineering, Shiraz University, P.O. Box 71345, Shiraz, Iran.
    Search for more papers by this author

Abstract

The present study combines simultaneously the definition of fluidisation and process intensification (thermally coupled heat exchanger reactor) concept and determines the optimum operational conditions in both sides of the reactor, using Differential Evolution (DE) optimisation approach. The exothermic hydrogenation of nitrobenzene to aniline takes place in a set of tubular reactors which is placed inside the naphtha reactors and thermally handle the endothermic reaction of reforming. A single objective function consists of four terms including aromatic mole fraction of the reformate and hydrogen production from each reactor in the endothermic side as well as the total molar flow rate of aniline and nitrobenzene conversion in the exothermic side is defined. Seven decision variables such as inlet temperature of exothermic and endothermic sides, exothermic molar flow rates for the first and the second reactors and the number of tubes are considered during the optimisation procedure. Temperature constraints have been considered in both sides during the optimisation in order to reduce the possibility of rapid catalyst deactivation by sintering. Results show approximately 464.4 and 598.9 kg/h increase in aromatic and aniline production rates in optimised thermally coupled fluidised bed naphtha reactor (OTCFBNR) compared with non-optimised case (TCFBNR), respectively. Such a theoretical study is necessary prior to designing new pilot plants and revamping industrial units. © 2011 Canadian Society for Chemical Engineering

Ancillary