Microcrystalline cellulose (MCC) is hydrolyzed to an appreciable extent (70 %) by using 1-(4-sulfonic acid) butyl-3-methylimidazolium hydrogen sulfate (IL-1) as effective catalyst. Valuable chemicals, such as 5-hydroxymethyl furfural (HMF) and furfural, are obtained in relatively high yields (15 % and 7 %, respectively). Interestingly, the introduction of FeCl2 as catalyst into IL-1 further enhances the catalytic activity, as proved by the higher conversion of MCC (84 %) and higher yields of HMF and furfural (34 % and 19 %, respectively) under the same experimental conditions, although small amounts of levulinic acid (LA) and total reducing sugars (TRS) were also found. The hydrolysis of MCC scarcely proceeded, or showed a lower efficiency, in the absence of catalyst (4 %) or with Al2O3 (7 %), inorganic acids (≤65 %), or several other ionic liquids (≤24 %) as catalyst. Dimers of furan compounds were detected as the main byproducts, as analyzed by HPLC–MS; from the mass spectrometry analysis, the components of the gas-phase products were determined to be methane, ethane, CO, CO2, and H2. A mechanism to explain the high activity of FeCl2 in the IL-1 system is proposed. Recycling of the IL-1 catalyst showed an almost constant activity during five successive trials. The simple and effective catalyst system may prove valuable in facilitating the energy-efficient and cost-effective conversion of biomass into biofuels and platform chemicals.
If you can't find a tool you're looking for, please click the link at the top of the page to "Go to old article view". Alternatively, view our Knowledge Base articles for additional help. Your feedback is important to us, so please let us know if you have comments or ideas for improvement.