Flow dynamics in pediatric rigid bronchoscopes using computer-aided design modeling software

Authors

  • Mitchell D. Barneck BS,

    1. Department of Bioengineering, University of Utah, Salt Lake City, Utah, U.S.A
    Search for more papers by this author
    • All authors contributed in some form in conception, generation and analysis of data, drafting of the manuscript, and/or manuscript revision.

  • J. Taylor Webb BS,

    1. Department of Bioengineering, University of Utah, Salt Lake City, Utah, U.S.A
    Search for more papers by this author
    • All authors contributed in some form in conception, generation and analysis of data, drafting of the manuscript, and/or manuscript revision.

  • Ryan E. Robinson BS,

    1. Department of Bioengineering, University of Utah, Salt Lake City, Utah, U.S.A
    Search for more papers by this author
    • All authors contributed in some form in conception, generation and analysis of data, drafting of the manuscript, and/or manuscript revision.

  • J. Fredrik Grimmer MD

    Corresponding author
    1. Division of Otolaryngology, University of Utah, Salt Lake City, Utah, U.S.A
    • Send correspondence to J. Fredrik Grimmer, MD, 100 North Mario Capecchi Drive, Suite 4500, Salt Lake City, UT 84114. E-mail: j.grimmer@imail2.org

    Search for more papers by this author
    • All authors contributed in some form in conception, generation and analysis of data, drafting of the manuscript, and/or manuscript revision.


  • Presented in part at the Combined Otolaryngology Spring Meetings for the American Society of Pediatric Otolaryngology, Las Vegas, Nevada, U.S.A., May 17, 2014.

  • The authors have no funding, financial relationships, or conflicts of interest to disclose.

Abstract

Objectives/Hypothesis

Observed complications during rigid bronchoscopy, including hypercarbia and hypoxemia, prompted us to assess how well rigid bronchoscopes serve as an airway device. We performed computer-aided design flow analysis of pediatric rigid bronchoscopes to gain insight into flow dynamics.

Study Design

We made accurate three-dimensional computer models of pediatric rigid bronchoscopes and endotracheal tubes. SOLIDWORKS (Dassault Systemes, Vélizy-Villacoublay, France) flow analysis software was used to analyze fluid dynamics during pressure-controlled and volume-controlled ventilation.

Methods

Flow analysis was performed on rigid bronchoscopes and similar outer diameter endotracheal tubes comparing resistance, flow, and turbulence during two ventilation modalities and in common surgical scenarios.

Results

Increased turbulent flow was observed in bronchoscopes compared to more laminar flow in endotracheal tubes of similar outer diameter. Flow analysis displayed higher resistances in all pediatric bronchoscope sizes except one (3.0 bronchoscope) compared to similar-sized endotracheal tubes. Loss of adequate ventilation was observed if the bronchoscope was not assembled correctly or if increased peak inspiratory pressures were needed. Anesthesia flow to the patient was reduced by 63% during telescope insertion.

Conclusions

Flow analysis illustrates increased turbulent flow and increased airflow resistance in all but one size of pediatric bronchoscopes compared to endotracheal tubes. This increased turbulence and resistance, along with the unanticipated gas distal exit pattern, may contribute to the documented hypercarbia and hypoxemia during procedures. These findings may explain why hypoxemia and hypercarbia are commonly observed during rigid bronchoscopy, especially when positive pressure ventilation is needed.

Level of Evidence

NA Laryngoscope, 126:1940–1945, 2016

Ancillary