Modification of multiwall carbon nanotubes by grafting from controlled polymerization of styrene: Effect of the characteristics of the nanotubes

Authors

  • Julio Albuerne,

    1. Institute of Polymer Research, GKSS Research Centre Geesthacht GmbH, Max-Planck-Str. 1, Geesthacht 21502, Germany
    Search for more papers by this author
  • Adriana Boschetti-de-Fierro,

    1. Institute of Polymer Research, GKSS Research Centre Geesthacht GmbH, Max-Planck-Str. 1, Geesthacht 21502, Germany
    Search for more papers by this author
  • Volker Abetz

    Corresponding author
    1. Institute of Polymer Research, GKSS Research Centre Geesthacht GmbH, Max-Planck-Str. 1, Geesthacht 21502, Germany
    • Institute of Polymer Research, GKSS Research Centre Geesthacht GmbH, Max-Planck-Str. 1, Geesthacht 21502, Germany
    Search for more papers by this author

Errata

This article is corrected by:

  1. Errata: Modification of multiwall carbon nanotubes by grafting from controlled polymerization of styrene: Effect of the characteristics of nanotubes Volume 48, Issue 14, 1683, Article first published online: 14 June 2010

Abstract

Linear polystyrene chains were grown from the convex surface of two commercially available multiwall carbon nanotubes (MWCNTs) with similar diameter but different lengths. The MWCNTs were supplied from Bayer Material Science® (purity >95%, external diameter = 13–16 nm, length = 1–10 μm, denoted MWCNTBMS95) and FutureCarbon GmbH (purity >99%, external diameter = 15 nm, length = 5–50 μm, denoted MWCNTFC99). The MWCNTs were oxidized with nitric acid, consecutively reacted with thionyl chloride, glycol or poly(ethylene glycol), 2-bromo-2-methylpropionyl bromide and finally with styrene under atom transfer radical polymerization (ATRP) conditions. The content of polystyrene grafted from the surface of the MWCNTs can be controlled by adjusting the molecular weight of the poly(ethylene glycol), the initiator concentration and the monomer to carbon nanotube weight ratio. Under comparable experimental conditions, a higher amount of polystyrene is grafted from the MWCNTBMS95 than from MWCNTFC99. The difference in dimensions and the state of aggregation of the carbon nanotubes influence the grafting from polymerization reactions, where relative shorter and tightly aggregated carbon nanotubes promote higher polymerizations yields than longer and less aggregated carbon nanotubes. The increase of the viscosity of the carbon nanotube dispersion decreases the polymer grafting content. © 2010 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 48: 1035–1046, 2010

Ancillary