Identification of kinetic models for the assessment of reaction hazards
Version of Record online: 30 JAN 2007
Copyright © 2007 American Institute of Chemical Engineers (AIChE)
Process Safety Progress
Volume 26, Issue 3, pages 209–220, September 2007
How to Cite
Kossoy, A. and Akhmetshin, Y. (2007), Identification of kinetic models for the assessment of reaction hazards. Proc. Safety Prog., 26: 209–220. doi: 10.1002/prs.10189
- Issue online: 3 AUG 2007
- Version of Record online: 30 JAN 2007
- kinetics evaluation;
- parameters estimation;
- hazard assessment
The assessment, control, and mitigation of reaction hazards is primarily based on the use of kinetic models. These kinetic models are used for the assessment of reaction hazards, the operation and control of the reactor, the design of emergency relief systems, estimation of the consequences of a reaction runaway, etc. The validity of these assessments depends highly on the validity of the kinetic model employed.
Several steps are required to identify a suitable kinetic model. This includes:
Selection of the model type.
Estimation of the model's parameters using available data.
Validation of the model.
This article discusses each of these steps in detail and identifies problems associated with each step. Several practical examples are used to demonstrate these problems.
The results show that (1) the results are sensitive to a number of assumptions, (2) mistakes may originate from misinterpretation of the thermal data, and (3) computational methods do exist to provide suitable kinetic models for hazard assessment.
The analysis employed assumes a batch-reaction system, since most of the kinetic data available is derived from batch calorimetric equipment. © 2007 American Institute of Chemical Engineers Process Saf Prog, 2007