GPS signals reflected off the surface of the Earth can be detected by receivers aboard occulting Low Earth Orbiters (LEOs). In this work, carrier phase interferometry between the reflected and direct occultation signals is performed to infer its relative delay at centimetric error. Our analysis shows that submeter sensitivity on the surface heights can formally be reached with this technique. The potential applications to polar ice altimetry are discussed.
If you can't find a tool you're looking for, please click the link at the top of the page to "Go to old article view". Alternatively, view our Knowledge Base articles for additional help. Your feedback is important to us, so please let us know if you have comments or ideas for improvement.
 During the last decade, several studies have assessed the geophysical content of Global Positioning System (GPS) signals reflected from the surface of the Earth, especially over the ocean. A passive bistatic radar concept, proposed by Martín-Neira , would take advantage of the large number of transmitters currently emitting L band coded signals (∼30 satellites for the GPS constellation, ∼10 for the Russian GLONASS), and the enlargement of the global navigation satellite systems with GALILEO, a European constellation planned for the near-future, to perform multistatic simultaneous observations from ground- air- or space-based platforms, with great spatial and temporal coverage. So far, most experimental work has been focused on applications from ground [Martín-Neira et al., 2001], aircraft [Garrison et al., 1998] or stratospheric balloons [Cardellach et al., 2003], for altimetry and surface roughness measurements [Zavorotny and Voronovich, 2000; Rius et al., 2002]. Whereas centimeter precision has been reported for ground-based carrier phase altimetric observations [Treuhaft et al., 2001], and 5-cm for airborne platforms group delay measurements [Lowe et al., 2002b], the altimetric performance from space is still to be clarified. Lowe et al. [2002a] described the first GPS reflection gathered from space, while Beyerle et al.  identified reflected GPS signal leaking into occultation data collected by a Low Earth Orbiter (LEO). Using radio-holographic technique, Beyerle et al.  inferred a precision of ∼100 m in the determination of reflection surface heights. This paper is the first to present GPS reflected-to-direct carrier phase interferometry from space-borne receivers. Data from standard GPS LEO occultations with ice-reflection leakage (GPS-R/Occ) are analyzed. The relative delay between the direct and reflected signals are inverted to yield the heights of the reflection points, by taking advantage of the good knowledge of the atmospheric correction, which is the main retrieval product of the GPS LEO occultation instrument. The results suggest that the interferometry technique offers submeter sensitivity to ice topography (see the auxiliary material) with a few km horizontal resolution.
2. Carrier Phase Interferometry
 During the last seconds of an occultation, reflected signals may reach the LEO horizon-looking antenna with Doppler frequencies within the receiver bandwidth [Beyerle et al., 2002]. The output of the GPS occultation receiver is the peak of the complex cross-correlation function between the incoming signal and a replica or model of it, and it reproduces the features of the electromagnetic field reaching the antenna. When both the direct and the reflected fields reach the antenna, either the total field or the correlation function, with amplitude A and phase ϕ, can be modeled as
where Ad and Ar are the amplitudes of the direct and the reflected components, ϕd and ϕr are their respective phases, with ϕd = ϕ0 + kρd and ϕr = ϕ0 + kρr, k being the GPS carrier wavenumber, ρ for distance or delay in length units, and ϕ0 being the initial phase bias. The interferometric phase, ϕI = (ϕr − ϕd) = k(ρr − ρd) = kΔρ is not a constant during an occultation, thus inducing a fringe pattern in the amplitude and phase of the total field.
 The smoothed value of the total field is dominated by the direct contribution, Ad ≡ , where stands for its real and for its imaginary part. The fringe oscillations around correspond to some projection of the reflected signal. Then, equation (1) becomes
 In order to remove non-interferometric modulations, the smoothing is carried out on windows of twice the interferometric period, Tw = 2TI = 2/∣fI∣, where ∣fI∣ is estimated from the Fourier analysis of the data: ∣fI∣ = ∣fr − fd∣. The amplitude as received by the occultation CHAMP-GPS51 2001-05-14-01:15 is displayed in Figure 1 (top). For each cycle added or subtracted in the interferometric phase, the reflected-to-direct delay changes by 1 L1 GPS carrier wavelength, λ ∼ 0.19 m. Because both branches of the signal eventually collapse into a single one, the interferometric carrier phase measurement is not cycle-ambiguous after anchoring to zero at the collapsing time, tc. The sequence of oscillations in phase residuals are in skewed quadrature with respect to the amplitude oscillations (not at 90°, but toward amplitude's minimums, as expected for interferometric behavior), see Figure 1 (middle). This fact supports that these oscillations are interferometric fringes rather than noise or mismodeled modulations. The interferometric phase computed through equation (3) is displayed in Figure 1 (bottom).
 Finally, the reflected-to-direct relative delay is obtained from the interferometric phase by aligning the cycles and translating to length units. Data corresponding to t > 64s have been rejected, because of the difficulties in appropriately detrending the last interferometric cycle. Instead, the delay is extrapolated toward tc, and anchored to 0. Uncertainty of 1 second in tc determination yields to ∼1 mm error in the relative delay, which may be considered the formal accuracy of this delay measurement. Figure 2 shows that the procedure results in a few cm formal error, dominated by the sampling resolution of the cycle. The resolution improves along the occultation because the interferometric frequency slows down, enabling better sampling of the cycles. The noise in the receiver tracking loops introduces few mm uncertainty. The carrier phase ambiguity is fixed through the collapsing time, tc, when Δρ = 0, and the cycles are added from that point in reverse order of time.
3. Geophysical Information Content
 The reflected-to-direct relative delay may have several contributions. Most of the standard sources of delay in the GPS signal, however, are here canceled because of the differential nature of the observation. Our work assumes that the reflected-to-direct delay, Δρ can be modeled as
The superscripts r and d stand for reflected and direct signals; ρgeo stands for the geometrical delay; ρtrop is the extra delay induced by the troposphere in each ray; ρiono is the delay introduced by the electronic content of the higher atmosphere; ρinstr are instrumental errors; N is the refractivity profile; and n unmodeled noise. The multipath due to the topography feature of horizontal scales smaller than the Fresnel zone, ∼19 km × 1 km, or roughness could also bias the result, ρrgh. In this preliminary study, we neglect this effect, but keeping in mind that it can be a source of inaccuracies. We also assume the canceling of instrumental and ionosphere perturbations. Under such assumptions, the relative delay is therefore only a function of the locations of the receiver, the transmitter and the specular reflection point respectively, along with the refractivity profile of the atmosphere N. The receiver and transmitter locations are known with accuracy better than a few cm, while the refractivity profile is the main retrieval product of the GPS occultation mission. Thus the sole unknown of the system is the location of the specular reflection.
 For a given refractivity profile, receiver and transmitter locations and an a priori reference surface, S, the trajectory of both reflected and direct signals may be estimated by a forward ray tracing tool (RTT), providing the location of the specular point and the model for the relative delay: ΔρRTT = Δρ(S, , N). If the model does not match the data, we can adjust the vertical component of the surface as S + δS so that Δρdata = ΔρRTT(δS; S, , N). In this fashion, it is possible to infer the elevation of the reflecting surface with respect to the reference.
3.1. Topographic Profile
 In order to generate topographic profiles from the relative delay, the misfit at each 20-ms data sample for different surface height corrections, δS, are computed:
where σdata(ti) is the formal error of the delay at the sample ti. For the inversion of CHAMP-GPS51 2001-05-14-01:15 the range δS = −8.9 to 0.9 m has been evaluated in steps of 10 cm. The time series altimetric solutions, δS*(ti), are picked as the surface's elevation that gives a minimum misfit at each ti. As shown in Figure 3, the 20-ms sampling inversion has uncertainties of the order of ∼2 m (range of δS with differences with the data within the data confidence). When smoothing the solution in 0.2-sec windows, the resultant profile has an averaged RMS dispersion of 0.70 m and horizontal spacing of ∼1 km, which establishes the formal vertical and horizontal resolutions of the approach.
 The lack of in-situ data at high polar latitudes hinders the validation of the results. We found a GPS-R/Occ event (CHAMP-GPS39 2003-05-31-19:19) which occurred within two weeks and ∼30 km of an Airborne Tropospheric Mapping Lab (ATM) track, cross-comparable with a Digital Elevation Model (DEM) [Bamber et al., 2001]. The ATM precision is of the order of 10 cm, but because of the coarse vertical resolution of the DEM (∼10 m RMS accuracy) the GPS interferometric product has been inverted into topographic profiles at 6 m vertical resolution mode. Figure 4 contains the elevation map of the region together with both the airborne laser and GPS-R/Occ altimetric estimates and the interpolation of the DEM under those tracks (top). The gradient of the terrain obtained by GPS-R/Occ agrees with the gradient predicted by DEM with RMS dispersion of 6.6 m, i.e., within the DEM resolution. The GPS-R/Occ to DEM offset is 294 m, same order of magnitude as the ATM to DEM bias for this portion of flight (232 m). The ATM to DEM offset is not a constant value, but changes at different areas/tracks, and the variations are as large as the difference between the ATM and the GPS-R/Occ biases (∼60 m). This cross-comparison represents a preliminary proof of concept of GPS-R/Occ as a topographic tool, although dedicated calibration campaigns should be conducted to verify the submeter formal precision that we have achieved with this technique.
4. Discussion and Conclusions
 This paper presents the first study on space-based carrier phase interferometric delay between direct and reflected GPS signals. This product, with a few centimeter formal resolution and better formal accuracy, is a differential delay enabling the cancellation of several error terms. This sole achievement opens a new complementary way to process GPS LEO occultation data, with potential geophysical applications in tropospheric refractivity and surface's altimetry. The sensitivity of this observable to variations of the reflecting surface's elevation has been evaluated.
 Two topographic ice-profiles have been generated, which are located at the North Pole (89.73°) and Greenland. The former event has been inverted using a high-resolution approach (10 cm steps), resulting in 0.70 m vertical precision at ∼1 km horizontal sampling. The second event, on Greenland, has been inverted in a low-resolution mode and cross-compared with ATM and DEM yielding agreement within the data sources resolution. The validation example presents a preliminary proof of concept for utilizing this kind of measurements as a remote sensing tool for ice topography.
 Further validation work is required to assess the roles of noise sources and mismodeled parameters. Future work is also intended to determine the spatial-temporal coverage of the ice reflection events and to evaluate the performance of the technique on ocean reflections. Potential application of the interferometric technique for refining the refractivity profiles of the lower troposphere will also be considered. The analysis of archives of past occultation data could be of great interest for the scientific community, filling a temporal and spatial gap on polar regions back to 1995 (GPS-MET, CHAMP, SAC-C). The improvement of receiver tracking to enhance the measurements of the reflection events could also be tackled, especially in views of its impact on upcoming missions, such as COSMIC [Lee et al., 2001] or ACE+ [Battrick, 2004] constellations, which will provide an unprecedented rich source of GPR-R/Occ events.
 The research described in this paper was carried out by the Jet Propulsion Laboratory, California Institute of Technology, under contract with the National Aeronautics and Space Administration and a NASA funded National Research Council associateship program. E. C. was an NRC associate at NASA/JPL.