Corresponding author: A. L. Robinson, Center for Atmospheric Particle Studies, Carnegie Mellon University, 5000 Forbes Ave., Pittsburgh, PA 15213, USA. (email@example.com)
 Experiments were performed in an environmental chamber to characterize the effects of photo-chemical aging on biomass burning emissions. Photo-oxidation of dilute exhaust from combustion of 12 different North American fuels induced significant new particle formation that increased the particle number concentration by a factor of four (median value). The production of secondary organic aerosol caused these new particles to grow rapidly, significantly enhancing cloud condensation nuclei (CCN) concentrations. Using inputs derived from these new data, global model simulations predict that nucleation in photo-chemically aging fire plumes produces dramatically higher CCN concentrations over widespread areas of the southern hemisphere during the dry, burning season (Sept.–Oct.), improving model predictions of surface CCN concentrations. The annual indirect forcing from CCN resulting from nucleation and growth in biomass burning plumes is predicted to be −0.2 W m−2, demonstrating that this effect has a significant impact on climate that has not been previously considered.
If you can't find a tool you're looking for, please click the link at the top of the page to "Go to old article view". Alternatively, view our Knowledge Base articles for additional help. Your feedback is important to us, so please let us know if you have comments or ideas for improvement.
 Although biomass burning likely has a significant impact on the climate system, global model predictions of CCN concentrations from biomass burning are especially uncertain [Spracklen et al., 2011], complicating the quantification of aerosol indirect effects [Intergovernmental Panel on Climate Change (IPCC), 2007]. Biomass burning emission inventories used by global models are based on near-field measurements of fresh emissions but the biomass burning plume is a dynamic system in which dilution [Robinson et al., 2010] and oxidation [Hobbs et al., 2003; Yokelson et al., 2009] rapidly transform the direct (primary) gaseous and particle emissions as the plume is transported away from the fire. These transformations alter the chemical and physical properties of the primary particle emissions [Haywood et al., 2003; Hennigan et al., 2011], and thus, presumably, their effects on air quality and climate. However, these transformations are not included in global models and their effects on global CCN concentrations and the aerosol indirect effects are not well understood.
 In this study, we performed novel experiments to investigate the effects of photo-oxidation on particle number and CCN concentrations from biomass burning. We use the new experimental results to develop inputs for a general circulation model coupled with a comprehensive aerosol microphysics model (GISS-TOMAS), which represents, to our knowledge, the first global modeling assessment of particle nucleation and growth in biomass burning plumes. The model is used to predict the effects of photo-oxidation in fire plumes on global CCN concentrations and to quantify the resulting impact on climate through the cloud albedo effect.
 To investigate the atmospheric transformations of biomass burning emissions, smog chamber experiments were conducted as part of the third Fire Lab at Missoula Experiment (FLAME-III) at the US Fire Science Laboratory in Missoula, Montana. Experimental methods have been described in detail elsewhere [Hennigan et al., 2011]. Briefly, fresh (primary) gas and particle emissions from controlled laboratory burns designed to simulate open wild land fires were sampled into a 7 m3Teflon smog chamber. Filling the smog chamber diluted the emissions by roughly a factor of 20 compared to concentrations in the burn chamber. After characterizing the diluted gas- and particle-phase emissions in the smog chamber for 1.4 hr, the emissions were photo-oxidized by exposing them to a combination of natural and artificial lights. Oxidant (e.g., hydroxyl radical), trace gas, and aerosol concentrations inside the chamber were comparable to typical plume conditions [Hennigan et al., 2011]; therefore, the experiments investigate the transformations that occur within a few hours of the emissions entering the atmosphere. A total of 18 experiments with 12 different North American biofuels were performed under varying concentrations representative of ambient plume conditions (auxiliary material).
 Aerosol number concentrations and size distributions were measured in the size range of 10–500 nm with a scanning mobility particle sizer (TSI - model 3080 with TSI - model 3772). Cloud condensation nuclei (CCN) measurements were made with a continuous flow streamwise thermal gradient CCN counter (DMT) and a CPC (TSI - model 3772) after pre-conditioning the aerosols by humidification and subsequent drying [Engelhart et al., 2012]. OH levels were estimated from the measured decay of single-ring aromatic hydrocarbons with a calibrated proton-transfer-reaction mass spectrometer [Hennigan et al., 2011] (Ionicon).
 The experimental data were implemented into a global aerosol microphysics model, Goddard Institute for Space Studies General Circulation Model II-prime (GISS-GCM-II′) coupled to the TwO-Moment Aerosol Sectional microphysics algorithm (TOMAS). The base model setup has been described previously [Lee and Adams, 2010]. Additional biomass burning model inputs were derived from the experiments, and are described below. See the auxiliary material for additional model details.
3.1. Experimental Results
Figure 1 shows time series data from a typical experiment. The primary particle emissions were dominated by accumulation mode aerosol with a number median diameter of 135 nm (Figure 1a). Exposing the chamber to UV light initiated photochemistry that created a strong nucleation burst, increasing the particle number concentration inside the chamber by a factor of 9–10 (Figures 1a and 1b). These new particles then grew at a rate of 12 nm hr−1 to a median size of 60 nm over the course of the 4 hr experiment (Figure 1a), demonstrating that photo-oxidation also produced significant amounts of condensable vapors. Because of this rapid growth, many of the nucleated particles survived and contributed to the measured CCN concentrations. After 3.5 hours of photo-oxidation, about 60% of the CCN at 0.8% supersaturation resulted from growth of nucleated particles (Figure 1b); the newly formed particles also activated at 0.4% supersaturation (∼10% CCNnuc/CCNtot ratio at 0.4% SS). Field studies have reported nucleation in both fresh (<1 hr) [Hobbs et al., 2003] and aged [Andreae et al., 2001] fire plumes.
Figure 2 compiles nucleation and growth data from the entire set experiments. Figure 2aindicates that the primary particle number emission factors measured before photo-oxidation agree with literature data for fresh biomass burning emissions [Janhäll et al., 2010]. In 17 of 18 experiments, nucleation induced by photo-oxidation greatly increased the particle number (Figure 2b). The enhancement in particle number due to nucleation was highly variable, ranging from a factor of 1.9 to 26, with a median enhancement of 3.9. Since this nucleation likely occurs shortly after the emissions enter the atmosphere (sub-grid), model parameterizations based only on primary particle emissions likely substantially underestimate the contribution of biomass burning to particle number and CCN concentrations (Figure 2b). Unlike primary particle number emissions [Janhäll et al., 2010], particle number enhancements due to nucleation are not related to combustion efficiency (i.e., no correlation observed for orange symbols in Figure 2b).
 New particle formation was typically observed 30–60 minutes after initiating photo-oxidation, similar to the results plotted inFigure 1. Some of the delay is likely due to the lower limit of our particle size measurements (10 nm) because particle growth from clusters to 10 nm sizes is a dynamic process [Jiang et al., 2011]. Finally the new particle formation occurred in the presence of a significant condensational sink (average condensational sink of the primary particles was 53.8 hr−1), demonstrating that the production of condensable vapors was quite rapid.
 In order to become CCN, freshly nucleated particles must grow to roughly 50–100 nm, depending on supersaturation. Rapid growth was observed in every experiment; the median particle growth rate was 14 nm hr−1. Sized-resolved measurements of chemical composition with an Aerosol Mass Spectrometer indicate that this growth was due to secondary organic aerosol (SOA) formation [Hennigan et al., 2011]. Particle number enhancement was also correlated with the SOA production (R2 = 0.61, auxiliary material). Field studies report substantial SOA production in biomass burning plumes [Lee et al., 2008; Yokelson et al., 2009]. Figure 2c plots the measured mass of SOA produced relative to the amount of fuel consumed in each experiment.
 The rapid growth due to SOA formation resulted in a high survival probability for particle growth from 10 to 75 nm (Figure 2d) and creation of new CCN. Across all experiments, the median survival probability for particle growth from 10 to 75 nm was 18%. Even at the end of the experiment, there is clear evidence of continued particle growth (Figures 1 and S7), indicating sustained production of condensable vapors. Therefore, additional photo-oxidation is expected to result in continued growth and further increase CCN concentrations.
 The 10 nm particle formation rates (J10) were strongly correlated with inferred H2SO4 concentrations (R2 = 0.60), but the inferred H2SO4 concentrations were, on average, a factor of 20 too low to explain the observed growth rates (Figure S2). Therefore, H2SO4 likely plays a key role in the first steps of the formation of these particles, but their growth is dominated by SOA, in line with a number of recent field and laboratory observations [Kuang et al., 2010; Kirkby et al., 2011].
3.2. Modeling Results
 The aerosol indirect effect depends strongly on aerosol number and size [Pierce et al., 2007; Pierce and Adams, 2009; Spracklen et al., 2011], therefore nucleation and growth in fire plumes may have an important effect on global climate. To investigate this hypothesis, data obtained from this study were used as input parameters for simulations conducted with the GISS-TOMAS global aerosol microphysics model. Because nucleation occurs so quickly in our experiments (<1 hr), it was treated in the model as an enhanced emission of 10 nm particles from biomass burning. The particle number emission factor was scaled using the median measured nucleation enhancement factor shown inFigure 2b. The production of condensable vapors in an oxidizing plume was defined based on the median measured SOA formation (3.51 g/kg, dashed line in Figure 2c). Additional details of the model, including these derived inputs, are available in the auxiliary material.
Figures 3a and 3b show maps of predicted surface CCN concentrations (0.4% supersaturation) averaged over the dry season (September and October) when there is significant biomass burning (a similar figure for the wet season is in the auxiliary material). The revised model that accounts for nucleation and growth induced by photo-oxidation of biomass burning emissions increases predicted CCN concentrations by as much as a factor of 5 over base model simulations (Figure 3c). Consistent with observations [Anderson et al., 1996; Andreae et al., 1988], the predicted enhancements are spread across large geographical areas, which underscores the global influence of biomass burning emissions.
 To evaluate the model, predicted surface CCN concentrations are compared to measurements in Amazonia and Africa taken over the past decade [Artaxo et al., 2002; Williams et al., 2002; Guyon et al., 2003; Ross et al., 2003; Andreae et al., 2004; Rissler et al., 2004]. The revised model performs significantly better (average model/measurement ratio = 2.1) than the base model (no biomass burning nucleation; average model/measurement ratio = 0.26) during the dry season (Figure 3d), suggesting that nucleation and growth of aerosols in biomass burning plumes impacted these locations. Other possible explanations for the underprediction of CCN levels by the base model include uncertainties in the model emission inventories and size distributions [Spracklen et al., 2011]. However, we believe that nucleation and growth in biomass burning plumes is a significant part of the explanation since we are using high estimates for primary biomass burning emissions. Further, analogous simulations performed in GEOS-Chem also showed systematic underpredictions by the base model that are difficult to reconcile based solely on primary emissions (auxiliary material).
 The revised GISS-TOMAS model predicts that new particle formation and growth in fire plumes has a significant impact on climate by altering cloud albedo (first aerosol indirect effect). The predicted change in the globally averaged annual radiative forcing due to these processes is −0.2 W m−2 (Figure 3e), which corresponds to about 30% of the best estimate of the aerosol indirect effect from the most recent IPCC assessment [IPCC, 2007]. Current model treatments do not account for the dynamic particle formation and growth in biomass burning plumes and therefore do not fully capture the air quality and climate effects of this important pollution source.
 We thank Sonia M. Kreidenweis for her contribution and leadership on the FLAME III study. We also gratefully acknowledge the efforts of Cyle E. Wold, Wei Min Hao, and Emily N. Lincoln in carrying out the FLAME-III study. Funding for FLAME III was provided by the National Park Service and Joint Fire Science Program and the EPA STAR program through the National Center for Environmental Research (NCER) under grant R833747. This paper has not been subject to the EPA's required peer and policy review, and therefore does not necessarily reflect the views of the Agency. No official endorsement should be inferred.
 The Editor wishes to thank two anonymous reviewers for assisting with the evaluation of this paper.