Get access

Rapid prototyping of anatomically shaped, tissue-engineered implants for restoring congruent articulating surfaces in small joints

Authors

  • T. B. F. Woodfield,

    1. Institute for Biomedical Technology, University of Twente, Enschede, The Netherlands
    2. Department of Orthopaedic Surgery & Musculoskeletal Medicine, University of Otago, Christchurch, New Zealand
    3. Centre for Bioengineering, University of Canterbury, Christchurch, New Zealand
    Search for more papers by this author
  • M. Guggenheim,

    1. Division for Plastic-, Hand- and Reconstructive Surgery, Department of Surgery, University Hospital Zurich, Zurich, Switzerland
    Search for more papers by this author
  • B. Von Rechenberg,

    1. Musculoskeletal Research Unit, Department of Equine Sciences, University of Zurich, Zurich, Switzerland
    Search for more papers by this author
  • J. Riesle,

    1. Institute for Biomedical Technology, University of Twente, Enschede, The Netherlands
    2. CellCoTec B.V., Bilthoven, The Netherlands
    Search for more papers by this author
  • C. A. Van Blitterswijk,

    1. Institute for Biomedical Technology, University of Twente, Enschede, The Netherlands
    Search for more papers by this author
  • V. Wedler

    1. Division for Plastic-, Hand- and Reconstructive Surgery, Department of Surgery, University Hospital Zurich, Zurich, Switzerland
    Search for more papers by this author

T. Woodfield, Department of Orthopaedic Surgery & Musculoskeletal Medicine, University of Otago Christchurch, PO Box 4345, Christchurch 8140, New Zealand. E-mail: tim.woodfield@otago.ac.nz

Abstract

Background:  Preliminary studies investigated advanced scaffold design and tissue engineering approaches towards restoring congruent articulating surfaces in small joints.

Materials and methods:  Anatomical femoral and tibial cartilage constructs, fabricated by three-dimensional fibre deposition (3DF) or compression moulding/particulate leaching (CM), were evaluated in vitro and in vivo in an autologous rabbit model. Effects of scaffold pore architecture on rabbit chondrocyte differentiation and mechanical properties were evaluated following in vitro culture and subcutaneous implantation in nude mice. After femoral and tibial osteotomy and autologous implantation of tissue-engineered constructs in rabbit knee joints, implant fixation and joint articulation were evaluated.

Results:  Rapid prototyping of 3DF architectures with 100% interconnecting pores promoted homogeneous distribution of viable cells, glycosaminoglycan (GAG) and collagen type II; significantly greater GAG content and differentiation capacity (GAG/DNA) in vitro compared to CM architectures; and higher mechanical equilibrium modulus and dynamic stiffness (at 0.1 Hz). Six weeks after implantation, femoral and tibial constructs had integrated with rabbit bone and knee flexion/extension and partial load bearing were regained. Histology demonstrated articulating surfaces between femoral and tibial constructs for CM and 3DF architectures; however, repair tissue appeared fibrocartilage-like and did not resemble implanted cartilage.

Conclusions:  Anatomically shaped, tissue-engineered constructs with designed mechanical properties and internal pore architectures may offer alternatives for reconstruction or restoration of congruent articulating surfaces in small joints.

Get access to the full text of this article

Ancillary